Check the charging port cover locking mechanism: First, the owner can check whether the charging port cover locking mechanism is physically damaged or hindered by foreign bodies. Sometimes, the locking mechanism may be due to prolonged use or external factors (such as rain)Dust) can cause stuck or damage. If there is a problem with the locking mechanism, the owner can try to gently clean or adjust it with the appropriate tool to restore its normal function.
Lubricant spray: Spray some lubricant, such as silicone oil or lubricating oil, on the rubber seal around the charging port cover, and then gently pull the charging port cover. Check the locking mechanism: the charging port cover of BYD Tang has a locking mechanism, and if there is a collision or impact during the vehicle driving, the locking mechanism will trigger, resulting in the charging port cover cannot be opened.
Need to go to the maintenance outlet for repair. Car charging port cover press bad will guideThe charging port cannot be fixed, which will cause dust to accumulate in the charging port, and it is necessary to go to the maintenance network to repair the damaged charging port.
First open the slow charging port cover, press the button on the inside of the main driver door panel (located on the left front door guard panel), open the charging port cover on the front grille, and slide the charging port cover upwards with your hand. Secondly, the electric switch is at the lower right side of the main driving side door, and there is an open button of the charging port switch. Press the switch to open the charging port cover and open the charging port cover on the front grille.
BYD Qin EV charging tutorial: When the vehicle is in the electrolytic lock state, you need to press the right charging port cover to automatically open. Open the corresponding charging port protection cover. Use the slow charge protection cover for slow charge, and use the fast charge protection cover for fast charge. To do this, press the charging gun lock button (usually located at the top of the handle), then insert the charging gun into the vehicle charging port and release the button.
Manually open the charging port cover Open the front hatch cover and press the open switch on both sides of the front grille to open the charging port cover by sliding the charging port cover upward295 HP (217 kW), peak torque 479 n · m; The battery pack has a capacity of 13 KWH and a maximum range of 70km in pure electric mode.
Center console air conditioning control panel below. Byd Qin's USB interface is located below the center console air conditioning control panel, there is a cover under the left button, open the cover to find the USB interface, the USB interface on the car is mainly used to charge electrical equipment, you can use the standard power supply on the car, through the USB interface to provide DC5V power, It can also be used as a fixed power supply interface for electrical equipment.
The closing force of the charging port cover is insufficient when the electric vehicle is drivingIn the event of vibration, the charging port cover will be insufficient due to its own closing force, which will easily lead to the deviation of the appearance gap of the charging port cover, affecting the appearance.
The solution is as follows: You need to find a screwdriver to first pull the lock back to the unlocked state, and then close the engine cover normally. Gently put it down, with two hands near the car headlights on both sides of the car can be pressed, when closing the car hood, can not be too hard, hard to close the hood will not only make the hood easy to deform, but also affect the normal work of the various components under the hood, in some cases will affect the sound insulation of the car.
If the hood doesn't close,It's possible the release handle in the cockpit jammed and didn't return to its original position. It may also be caused by rust or foreign matter stuck in the lock machine, you can spray some rust remoster or lubricant at the lock machine moving mechanism. If an accident has occurred in the front, it may be that the sheet metal is not properly aligned, resulting in misalignment between the latch and the lock machine. There's a switch on the left side of the main steering position. Just lift it up.
Ensure that the vehicle is powered off and unlocked; At the right rear of the vehicle, there is a charging port cover; Press the vehicle charging port cover, the charging port cover will automatically open; Inside the charging port, there are two charging interfaces: fast charging and slow charging. Before charging,Remove the protective cover from the corresponding charging port.
Operate the front hatch cover under the main engine to open the buckle. At this time, the front hatch cover can only open at a certain Angle because the charging port hatch door is overturned; Use a tool (such as a flat-head screwdriver) to pry off the emergency release protection cover in the flush port. Use a tool (such as a flat-head screwdriver) to flip the emergency release handle (red), reset the latch, and pull out the vehicle plug. 1 Unlocked: Unplug the vehicle. 2 Locked state: The vehicle plug cannot be pulled out.
BYD charging port cover can not be opened when pressed, usually because the locking mechanism of the charging port or the electronic control system fails. In order to solve this problem, the owner can try the following steps: Check the charging port cover locking mechanism: First, the owner can check whether the charging port cover locking mechanism has physical damage or foreign objects.
Battery failure: If 14 BYD Qin batteries fail, the charging port may not open. In this case, it is recommended to contact a professional technician to check the health of the battery and to replace the battery. Electronic key cannotOpen the charging port: If the electronic key cannot operate correctly to open the charging port, it may be a fault of the key itself. Try replacing the electronic key battery or contact a professional technician.
The charger is stuck. The charging cap is stuck. According to the inquiry of BYD's official website, the charging port is locked. The charging port of the BYD Yuan plus will be automatically locked when the charger is not inserted to avoid being accidentally opened. If the charging port is locked, it needs to be unlocked according to the instructions of the vehicle manual. The charger is stuck. The charger is stuck in the charging port, so the charging cover naturally cannot be opened.
Byd Qin EV in the "enable anti-theft" and "disable anti-theft" mode, the charging gun will be locked during the charging process, at this time, the charging gun will be locked, the user can unlock through the following ways: press the smart key unlock button to unlock; Press the micro-switch next to the door handle outside the main driving door to unlock; Press the central lock under the window inside the main driver door to unlock.
1. The charging method of BYD Qin plus is carried out in two ways: external charging and internal charging. Among them,External charging requires the use of charging piles, while internal charging is through the movement of the gasoline engine to charge the battery. A single charge consumes 13 KWH of electricity. The BYD Qin plus Dual Crown is equipped with a plug-in hybrid system consisting of a 5T engine and electric motor, with a maximum output of 295 HP (217 kW) and a peak torque of 479 nm.
2, BYD Qin charging process is as follows: First find the nearest charging station on the mobile APP, and then drive the vehicle over (if you have a private charging pile, this step can be omitted); Open the charging plate on the side of the car, and when the charging plate opens, you justYou can see the charging plug inside; Plug in the charging plug on the charging pile, and the vehicle dashboard will display the charging percentage and estimated charging time.
3, BYD Qin Plus supports two charging methods, including external charging and internal charging. External charging is mainly carried out through the charging pile, while internal charging relies on the movement of the gasoline engine to replenish the battery. The BYD Qin Plus consumes 13 KWH of electricity per charge.
4, BYD Qin plusdmi is a car that supports home power charging, and only needs to connect 220V home power supply to chargeElectricity, no need for professional equipment, convenient and fast. In addition to the convenience of charging methods, BYD Qin plus has many other advantages. The car body size of 4765mm, 1837mm, 1495mm, wheelbase reached 2718mm, the interior space is spacious and comfortable.
The introduction of Qin wireless charging cover is here, thank you for taking the time to read the content of this site, more information about wireless charging case, Qin wireless charging cover don't forget to find oh in this site.